主要技術參數
項目 | 單位 | |
最高卷繞速度 | m/min | ≤4000 |
筒管規格 | mm | Φ110x124x150 |
筒管夾頭長度 | mm | 150 |
最大卷裝直徑 | mm | Φ360 |
槽筒電機頻率 | Hz | 50-120 |
槽筒電機功率 | KW | 0.18-0.5W |
夾頭電機頻率 | KW | 50-100 |
夾頭電機功率 | KW | 2.2-4.4 |
1.1 技術參數
1.2公用設施技術參數
1.2.1氣控
a.空氣質量
在空氣進入卷繞頭氣動控制元件之前,壓縮空氣至少要滿足下列要求:
不純度: 顆粒密度 最大20mg/m3
油污: 最大1 mg/m3
壓力結露點: 在0.6MPa時,最大4℃
b. 壓力范圍 Range of Pressure
壓力P1: 0.60±0.05MPa(輸入壓力)
過濾精度: 0.05μm
P2的實際使用壓力,要根據紡絲工藝現場,每臺機械單獨調整。
1.2.2電源
頻率范圍: 50-60 Hz
電壓 380V
Main Technical Parameter:
Item | Unit | |
Max winding speed | m/min | ≤4000 |
Size of tube | mm | Φ110x124x150 |
Length of tube | mm | 150 |
Max diameter of full package | mm | Φ360 |
Frequency of barrel motor | Hz | 50-120 |
Power of barrel motor | KW | 0.18-0.5W |
Frequency of chuck motor | KW | 50-100 |
Power of chuck motor | KW | 2.2-4.4 |
1.1 Technical parameter
1.2 Technical parameters of utilities
1.2.1Air control
a. Air quality
Before air enters the pneumatic control element of winder, the compressed air shall at least meet the following requirements:
Impure rate: Particle density max20mg/m3
Oil pollution: max 1 mg/m3
Pressure dew point: max4℃, basis on 0.6MPa
b. Range of Pressure
Pressure P1: 0.60±0.05MPa(input pressure)
Filtering accuracy: 0.05μm
P2 is actual use pressure, shall be adjusted separately for each machine according to the spinning process site。
1.2.2 Power
Frequency range: 50-60 Hz
Voltage 380V